Our Services
Mineral Water Plant RO Plant Water Softening Plant Demineralised Plant Sewage Water Treatment Grey Water Treatment Effluent Treatment Water Treatment Plant Waste Water Treatment Plant Waste Water Recycling Sea Water Desalination Plant Nano Filtration Ultrafiltration Plants UV System Chemical Dozing System Swimming Pool Plant Swimming Pool Filtration Swimming Pool Equipment Domestic Product
 
sea water desalination plant

Which is suitable for most domestic, industrial, and agricultural uses.

A by-product of desalination is brine. Brine is a concentrated salt solution (with more than 35 000 mg/1 dissolved solids) that must be disposed of, generally by discharge into deep saline aquifers or surface waters with a higher salt content. Brine can also be diluted with treated effluent and disposed of by spraying on golf courses and/or other open space areas.

 OA reverse osmosis system consists of four major components/processes:

  •   Pretreatment
  • Rpressurization
  • membrane Unit for slat separation
  • pH correction   

Pretreatment: The incoming feedwater is pretreated to be compatible with the membranes by removing suspended solids, adjusting the pH, and adding a threshold inhibitor to control scaling caused by constituents such as calcium sulphate.

Pressurization: The pump raises the pressure of the pretreated feedwater to an operating pressure appropriate for the membrane and the salinity of the feedwater.

Salt Separation:

The permeable membranes inhibit the passage of dissolved salts while permitting the desalinated product water to pass through. Applying feedwater to the membrane assembly results in a freshwater product stream and a concentrated brine reject stream. Because no membrane is perfect in its rejection of dissolved salts, a small percentage of salt passes through the membrane and remains in the product water. Reverse osmosis membranes come in a variety of configurations. Two of the most popular are spiral wound and hollow fine fiber membranes (see Figure 17). They are generally made of cellulose acetate, aromatic polyamides, or, nowadays, thin film polymer composites. Both types are used for brackish water and seawater desalination, although the specific membrane and the construction of the pressure vessel vary according to the different operating pressures used for the two types of feedwater.

pH correction :

The product water from the membrane assembly usually requires pH adjustment and degasification before being transferred to the distribution system for use as drinking water. The product passes through an aeration column in which the pH is elevated from a value of approximately 5 to a value close to 7. In many cases, this water is discharged to a storage cistern for later use.
 
New Products